Particle ID/Index in ShapeWorks Studio

1

Hello ShapeWorks Community,

I’m exporting the particle scalars from ShapeWorks Studio to perform some numerical calculations. However, I find it difficult to match a particle with its corresponding xyz coordinates in the .csv file, especially when the number of particles goes large. Is there a way to view the ID/index of a selected particle in ShapeWorks Studio?

Many thanks,
M320322

2

Yes, if you hover over a particle and press either ‘1’ or ‘2’ on your keyboard, these control the two selection points and in the status bar will be the message “picked correspondence point: ”.

3

I was using v6.3.2 and couldn’t see that message, then I updated to v6.4.1 and it worked. Thanks a lot!